To replace an empty bobbin, To insert a previously wound bobbin – SINGER 626E6 Touch & Sew User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
To Replace an Empty Bobbin
1. Tighten bobbin halves securely.
2. With latch raised, slip bobbin (wide side up)
into bobbin case.
3. Snap latch down to secure bobbin.
4. Leave the slide plate open until you have finished
winding.
•m,
vr
Slip Bobbin into Case
Snap Latch Down
Insert Bobbin
To insert a Previously Wound Bobbin
1. Open slide plate; leave bobbin push-button in
sewing position.
2. Turn hand wheel to raise take-up lever to its
highest position.
3. Draw three or four inches of thread from bobbin
and place bobbin in case with thread leading off
to left side of latch.
4. Snap latch down to secure bobbin.
5. Close slide plate, allowing the thread to enter the
notch. (For instructions on starting to sew with
a previously wound bobbin, see page 19.)
Close Slide Plate
11