SINGER 626E6 Touch & Sew User Manual
Page 44
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
2 a
S
2 " : 3 .
4
. 5
S T I T C H
2
■ 5
^ T I T ;C :
h
; .. :w .1: X 'X
Pattern Selector: Zig-Zag
(W\WWWWWVV\)
Stitch Width Selector: 1 and 4
Needle Position: L
Throat Plate: General Purpose (DARN position)
Presser Foot: General Purpose
The space between the holes in the button determines
the stitch width settings. The 1 setting must always be
used to position the needle over the left hole and
fasten stitching. For buttons with standard hole spac
ing, use settings 1 and 4. For buttons with unusual
hole spacing, use setting 1 and increase or decrease
the width setting (4) as necessary.
To sew on two- or four-hole buttons, approximately
one inch in diameter or larger:
1. Set stitch width at 1 „ Position button under foot so
that the needle will enter the left hole. Lower foot.
Turn hand wheel toward you until needle rises out
of button and is just above the foot.
2. Set stitch width at 4= Then, when you begin to
stitch, the needle should enter the right hole of the
button. Take approximately six zig-zag stitches in
this position, ending on the left side.
3. To fasten stitching, return to stitch width 1 and
take approximately three stitches.
For best results with buttons smaller than one inch in
diameter, it is recommended that the Button Sewing
Presser Foot (available for separate purchase) be
used. See page 58.
42