SINGER 3314 User Manual

Page 57

Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".

Advertising
background image

• Turn the machine off.

• Insert the twin needle with the flat side of the

shank toward the rear of the machine.

• Thread the machine as you normally would

for single needle stitching, and pass the
thread through the left eye of the twin needle.

• Insert a second spool pin into the hole on the

top cover of the machine, as illustrated.

• Thread the machine in the usual way.

• Pass the thread through the remaining points,

making certain to omit the thread guide just
above the needle and pass thread through
right eye of needle.

• Draw both threads under the foot and back

along with the bobbin thread.

• Slowly lower the needle into the hole in the

needle plate by turning the hand wheel toward

you to make sure the needle clears the plate.

Caution:

Make sure not to use a stitch width greater

than mid point on the stitch width dial
when twin needle stitching.

55

Advertising
This manual is related to the following products: