Changing presser feet, Snap-on presser feet, One-piece presser feet – SINGER 771 Touch & Sew II User Manual
Page 12: The even feed foot
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Changing Snap^on Presser Feet
press Toe Upward
for Rerr.ovai
of New Presser Foot
under Shank
■ \, Lower Presser Bar and
Press Down on Screw
; to Secure New Foot
Changing One-Piece Presser Foot
CHANGING PRESSER FEET
Snap-on Presser Feet
These presser feet snap on and off a common
shank.
1. Raise needle to its highest position and
raise the presser foot.
2. Press toe of presser foot upward (as far as
it will go) and then snap down to remove.
3. Center the new presser foot under the
shank and lower the presser bar so that the
shank fits over the presser foot pin.
4. Press down on presser foot screw until foot
snaps into place.
To remove and replace shank of snap-on
presser feet, follow instructions below for
one-piece presser feet.
One-Piece Presser Feet
1. Raise needle to its highest position and
raise the presser foot.
2. Loosen presser foot screw and remove the
foot.
3. Hook new foot around the presser bar and
tighten presser foot screw.
NOTE: When changing one-piece presser
feet, you may insert the edge of a coin in the
slot to tighten presser foot securely.
Movable Arm.
Needle
Clamp
Changing Even Feed Foot
The Even Feed Foot
• Guide Even Feed foot into position from
back of machine, making sure the movable
arm straddles the needle clamp. Tighten
presser-foot screw securely with a coin.
10