Needle plates, Changing needle plate – SINGER 771 Touch & Sew II User Manual
Page 13
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
NEEDLE PLATES
General purpose needle plate, in place in
your machine, can be used with all presser
feet.
Straight stitch needle plate for use with the
straight stitch presser foot.
Chainstitch needle plate is one of three ac
cessories that must be used together for
ohainstitching.
For
instructions,
refer
to
“Chainstitching” beginning on page 35.
Feed cover plate for use when fabric feeding
is not desired.
General Purpose Needle Plate
Straight Stitch Needle Plate
Chainstitch Needle Plate
CHANGING NEEDLE PLATE
NOTE: Remove bobbin if it contains thread in
order to prevent thread being caught when
needle plate is replaced.
1. Raise needle to its highest point and raise
presser foot.
2. Open slide plate. Remove needle plate by
placing thumb under plate and lifting it up
and out.
3. Position new needle plate over the two pins
and release. (Needle plate is drawn into
position by magnets.)
4. Close slide plate.
Changing Needle Plate
11