SINGER 771 Touch & Sew II User Manual
Page 76
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Push Position Bracket
to Left
Swing Position
■■ BracketLatch
Away From You
REMOVING THE BOBBIN CASE
Make sure needle is at its highest position.
1. Open slide plate and remove needle plate
(see page 11 for instructions),
2. Remove bobbin. Keep bobbin push button
in sewing position,
3. Swing position bracket latch toward you.
Lift bracket and slide it to the right,
4. To remove bobbin case, twist case as
shown, and lift out.
REPLACING THE BOBBIN CASE
Make sure needle is at its highest position,
1, Keep bobbin push button in sewing posi
tion. Hold bobbin case by latch and, with
latch to right of needle, slip case in position
so that the groove engages hook channel,
2, Twist bobbin case as shown, until latch is
in center.
3. Push position bracket to left until it snaps
down, locking bobbin case in place,
4, Swing position bracket latch away from you
to lock bracket in place,
5. Replace bobbin and snap latch down,
6. Replace needle plateand close slide plate.
Replacing Bobbin Case
74