Removing and replacing top cover, Removing and replacing, Bottom cover – SINGER 771 Touch & Sew II User Manual
Page 75: Removing and replacing bottom cover, Removing covers, bobbin case, and bulb
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
removing covers,
bobbin case, and bulb
CAUTION: Before removing covers, bobbin
case, and light bulb, disconnect power-line
plug from your electrical supply.
REMOVING AND REPLACING
TOP COVER
Move take-up lever to a low point and lower the
presser foot.
1. Loosen screw
A
completely, lift up right
end of top cover, and slide cover toward
left and off machine.
2, Replace cover by positioning it on top of
arm with a slight overhang on left side;
slide cover to the right until it locks in
place. Replace and tighten screw
A.
Removing and Replacing Cover
REMOVING AND REPLACING
BOTTOM COVER
1. Disconnect machine plug from electrical
receptacle at right end of machine.
2. Tilt machine back and remove four screws
shown at right. A rubber cushion will be
removed with one of the screws. Pull cover
toward you to remove.
3. Replace bottom cover by aligning screw
holes in cover with screw holes in machine.
Push cover against machine to snap it into
place. Replace and tighten four screws.
Screws
Removing and Replacing Bottom Cover
73