SINGER 771 Touch & Sew II User Manual
Page 64
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BORDER DESIGNS
Border designs that add a decorative touch to
wearing apparel and household Items can be
created
by
combining different types of
straight stitching and zig-zag stitching. Simple
or elaborate, delicate or bold, they can be var
ied to suit the application. Use them as you
would a braid or to simulate horizontal, vertical
or bias stripes on plain fabric.
Procedure
Mark or crease fabric for the center line of first
row of stitching. If spacing between rows is not
greater than 1 /2 inch (1,3cm), gauge additional
rows with the presser foot. If spacing is wider,
m
Border Design
mark for each line of stitching. Use a backing of
crisp lawn, organdy or organza and be sure to
make a test sample on a swatch of your fabric
to check stitch settings and thread tension.
APPLIQUE
Applique adds beauty and interest to clothing
and household linens. You can create your
own design, trace a simple outline from a col
oring book, or use a motif cut from a printed
fabric. Fabrics of like or different texture com
bine equally well.
Use a closely spaced, fairly narrow zig-zag
stitch. Although you may vary stitch width to
accommodate fabric weave or texture, never
allow the stitch to be too wide.
When appliqueing, make a test sample to help
you decide which of the following meXhode is
more appropriate for your fabric and design.
Preparation
♦ Baste applique design to fabric.
• Outline design with straight stitching (use a
short stitch).
♦ Remove basting and press.
• Attach special purpose foot and general
purpose needle plate.
ШХЬой
#1—Trimming alter Stitching
Method #1
1. Set stitch width dial. Adjust stitch length in
the FINE area of the stitch control.
2. Outline the entire design with applique
stitching.
3. Cut away the fabric on the outer edges of
the stitching with embroidery scissors.
Method #2
1. Trim outside edges close to straight stitch
outline of design.
2. Set stitch width dial. Adjust stitch length in
the FINE area of the stitch control
3. Overedge the design with satin stitching.
This step will produce a smooth, lustrous
finish that requires no additional trimming.
62