Starting a seam, Guiding and supporting fabric – SINGER 771 Touch & Sew II User Manual
Page 24
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
starting a Seam
Stitching a Seam
Guiding and Supporting Fabric
Applying Gentle Tension
Applying Firm Tension
STARTING A SEAM
1. With presser foot raised, turn hand wheel
toward you to position needle in fabric about
1/2 inch (1.3cm) from starting edge.Lower
the presser foot.
2. Press reverse-stitch lever all the way down
and hold in place. Backstitch to edge of
fabric for reinforcement.
3. Release reverse-stitch lever and stitch in
forward direction.
GUIDING AND SUPPORTING FABRIC
Most fabrics need only to be guided in front of
the presser foot Some fabrics, however, re
quire support while being stitched, as shown.
These fabrics require using the straight stitch
presser foot.
CAUTION: Do not puli the fabric while you are
stitching as this may deflect the needle, caus-
ing it to break,
• For filmy sheers, knits, tricot, etc., apply
gentle tension by holding seam in front and
back of the presser foot.
♦ For stretch fabrics, apply firm tension front
and back when stitching in the same direc
tion as the stretch. For seams not on the
stretch direction, stitch in the conventional
manner, guiding fabric in front of the presser
foot.
22