SINGER 771 Touch & Sew II User Manual
Page 46
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
BAR-TACK BUTTONHOLES
• Pattern; Plain Zig-Zag |
• Stitch Width: 2% and 5 or to suit fabric
• Needle Position: L
• Stitch Control: In
FINE
area
• General Purpose Needle Plate
• Special Purpose Foot (Only)
Marking Lines
Always make a test buttonhoie on a sample of
your fabric. Be sure to duplicate the thickness
of the garment and include interfacing if ap
propriate.
BUTTONHOLE LENGTH
First decide how long the opening needs to be.
This will depend on the diameter and thickness
of the button. To find the right length, cut a small
slit in a scrap of your fabric and gradually
enlarge it until the button slips through easily.
Then add at least 1/8 inch or 3mm (1/16 inch,
or 1.5mm for each bar tack, the closing at each
end of buttonhoie), and mark the fabric as il
lustrated. This bar-tack measurement is ap
proximate; on some buttonholes, you may need
to increase it to arrive at pleasing proportions.
Length of
Cutting Space
Bar Tacks and
Side Stitching
STiTCH WIDTH SETTINGS
Next, determine the two stitch width settings
that you wiii need: one for side stitching and
one for bar tacks. Settings 2% and 5 are il
lustrated below, although other combinations
may be used, as long as combined widths of
side stitching does not exceed the width of
the bar tacks.
A
A ^
3 A S
Selector
BÌ2VZ
Bimsmchim
BarTacks
1 {
. A R
(
2 - 3
A J >
............................
.X
mrTTrm 1Tmmr
Selector
atS
44