SINGER 771 Touch & Sew II User Manual
Page 19
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
/
0':4K7r>
/f
VVi
/
^
/
/ Insert Bobbin
Close Slide Plate
/■"o
Replacing a Wound Bobbin
REPLACING A WOUND BOBBIN
Raise needle to Its highest position.
1 Open slide plate; leave bobbin push button
in sewing position.
2. Draw about four inches {10cm) of thread
from bobbin and place bobbin in case with
thread leading off to right side of latch.
Snap latch down to secure bobbin.
3. Close slide plate, allowing the thread to
enter the slot in the slide plate. Then raise
the bobbin thread as instructed below.
RAISING THE BOBBIN THREAD
1. Hold needle thread lightly with left hand
and turn hand wheel slowly toward you so
that needle enters needle plate,
2. Continue turning hand wheel until needle
rises and brings up bobbin thread in a loop.
3. Undo the loop and place both threads under
the presser foot, laying them diagonally to
the right Position needle in fabric where
desired, lower the presser foot and stitch.
Raising
the Bobbin
Thread
Stepi
17