Adjusting dials – SINGER 771 Touch & Sew II User Manual
Page 28
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
adjusting dials
SETTING PATTERN DIAL
Before moving the dial, make sure buttonhole
dial is in OFF position and needle is above
fabric.
Push the pattern dial in and turn it until de
sired zig-zag stitch pattern is between the red
lines.
To produce a Flexi-Stitch pattern, the stitch
control dial must be turned to the ^ setting.
TTWM
»llj............
i ■: y
{
i
,,s
.. ... ........
Tsffsi?
: X • ••y-:
H
• Push in
• Rotate
• Release
ADJUSTING STITCH PLACEMENT
Before moving needle position dial, move stitch
width dial to 5, and make sure buttonhole dial is
in OFF position and needle is above fabric.
Needle position setting A places the needle
in center stitching position. Settings t and B
place the needle in left and right stitching
positions at stitch widths less than 5.
Setting A is used most often. Settings L
and R are for special placement of stitching.
For example, an
B
setting is required for two-
step buttonholing and an L setting for button
sewing and twin-needle work. An L or R set
ting can be used to place narrow zig-zag
stitching to the left or right of center in
decorative work.
To adjust stitch placement, turn needle posi
tion dial until desired setting is aligned with
red line.
Buttonhole Dial
in OFF Position
t A «
Adjusting Stitch Piacement
i. A R
Left Needle Position
Center Needle Position
Right Needle Positron
26