Changing the bobbin – SINGER 771 Touch & Sew II User Manual
Page 18
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Removing Bobbin
Open Slide Plate and Raise Latch
/ ■ ^ f . V ' V
-X
/
/
/■
;■'
’Vf^--:-. Ч
Ч
/ / / ,/
Lift Out Bobbin
Replacing Empty Bobbin
..........
Л
X .
V ■ ■
.-г'-Л,
> У
7 ^
.
V —
/
'' '
■\
/
/ /
■:
.
< /
Slip Bobbin into Case
f/ 'x..^;-^:r v-.
/ /'
/
\
/
/
\...
■ <, /
Snap Latch Down
changing the bobbin
REMOVING THE BOBBIN
Raise needle to its highest position.
1. Open slide plate; leave bobbin push button
in sewing position,
2. Raise bobbin latch by inserting fingernail
under end of latch at center of bobbin.
3. Insert fingernail under rim of bobbin im
mediately to right of latch and remove the
bobbin.
REPLACING AN EMPTY BOBBIN
1. Make sure bobbin halves are securely tight
ened.
2. With latch raised, slip bobbin (wide side
up) into bobbin case. Then snap latch down
to secure bobbin.
3. Leave the slide plate open until you have
finished winding,
REMOVING THREAD FROM BOBBIN
If there is not much thread left on the bobbin,
you do not need to remove bobbin from ma
chine— simply pull the thread end through
the needle plate.
If there is a lot of thread left and you do not
wish to reserve it by setting aside the bobbin
for future use, remove the bobbin, unscrew the
two halves, and remove all the thread at once.
Then screw the two halves together, tighten
ing securely.
Removing Thread from Bobbin
16