SINGER 771 Touch & Sew II User Manual
Page 77
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REPLACING THE SLIDE PLATE
You will not have any occasion to remove the
slide plate. However, if it should accidentally
become disengaged from the machine, it is
easily replaced.
• Raise the presser foot and make sure needle
is in its highest position.
• Place slide plate in slide way with the front
edge close to, but not covering, the retain
ing spring (as shown).
• With a small screwdriver, lift each end of the
spring into each of the side grooves on the
underside of the plate.
• Draw the plate gently toward you and fully
engage the spring.
• Close slide plate.
Lift Retaining Spring ''
into Slide Plate Grooves
Replacing the Slide Plate
CHANGING THE LIGHT BULB
Caution:
Before chmging fight bulb make
sure you have discorrnected power-fine
plug from electrical outlet
Removing Bulb. With thumb of right
hand, push in and down on tab of light
lens and lower the light bracket Oo not
attempt to unscrew the bulb. Press it up
into the socket and at the same time turn
bulb over in direction shown to unlock the
bulb pin.
Caution:
Be sure to use a 15 watt bulb
only.
Replacing Bulb. Press new bulb into
socket, with bulb pin entering slot of
socket, and turn it over in direction shown
to lock bulb in position. Push entire as
sembly up until it snaps in position.
75