Setting up your machine, Branchement de la machine – SINGER WSL2000 (Part 1) User Manual
Page 10
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
SETTING UP YOUR MACHINE
1. Wipe off excess oil in the needle plate and bed areas.
2. FOOT CONTROL
Push foot control plug into connector socket, and connect
the power line plug into power supply outlet,
3. POWER/UGHT SWITCH
Your machine will not operate unless the power/light switch
is turned on. This same switch controls both machine power
and sewing light.
When leaving the machine unattended, or servicing the
machine, remove the power line plug from supply outlet.
4. OPENING FRONT COVER
To open front cover, pull it to the right and down towards
you.
POLARIZED PLUGS CAUTION (USA only)
This product is equipped with a polarized alternating current
line plug (a plug having one blade wider than the other).
This plug will fit Into the power outlet only one way. This is a
safety feature. If you are unable to insert the plug fully into
the outlet, try reversing the plug. If the plug should still fall to
fit, contact an electrician to replace the obsolete outlet. Do
not defeat the safety purpose of the polarized plug.
Use Yamamoto Electric, Model YC-482E with this sewing
machine.
5. OPENING WORKING TABLE
To open working table, pull the release lever towards you
with your right hand.
Illustration * I ; Connector socket
* n : Power/light switch
* II: Release lever
* IV: Working table
*V : Front cover
BRANCHEMENT DE LA MACHINE
1. Nettoyer l’excès d’huile sur la plaque-aiguille et ses
alentours.
2. RHEOSTAT
Plaçer la fiche du rhéostat dans la prise extérieure de la
machine, relier la prise électrique à votre prise murale.
3. INTERRUPTEUR LUMIERE ET MACHINE
Votre machine ne fonctionne que lorsque l'interrupteur de
lumière est en position de marche. Il commande la lumière
et le contact électrique général de la machine.
Lorsque vous n’utilisez pas la machine ou lors du nettoyage,
veillez à la débrancher de la prise de courant.
4. OUVERTURE DU CAPOT INFERIEUR FRONTAL
Pour ouvrir le capot frontal, le tirer vers la droite puis
l’abaisser vers vous.
5. OUVERTURE DU CAPOT LATERAL (TABLE DE
TRAVAIL)
Pour ouvrir la table de travail, tirer le levier vers vous avec
main droite.
Illustration * I : Prise
* 11 : Interrupteur
* III : Levier de dégagement du carter latéral
IV : Capot lateral
* V ; Capot inferieur frontal