SINGER 518 Stylist User Manual
Page 15
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Tension Disc
Pass Thread Through
Hole in Bobbin
• Place thread spool on spool pin over
felt. Lead thread around bobbin winder
tension disc and through small hole in
bobbin (from the inside).
• Place bobbin on holder and turn bobbin
winder switch to WIND.
•
Hold thread as shown and start the
machine. Cut off thread end when
winding is well under way.
• When required amount of thread has
been wound (winding will stop by
itself when bobbin is full), stop the
machine and cut connecting thread.
•
Turn bobbin winder switch to SEW
and remove bobbin from holder.
•
• Press hand wheel disc for sewing.
Bobbin Winder Switch
Press Here
for Sewing
13