Removing and replacing top cover, Removing and replacing bottom cover, Removing and replacing – SINGER 518 Stylist User Manual
Page 64: Carrying case base, Face plate, Removing covers, bobbin case and bulb
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
removing covers, bobbin case and bulb
D
CAUTION: Before removing covers, bobbin case, and light bulb,
disconnect power-line plug from electrical supply.
REMOVING AND REPLACING
TOP COVER
• To remove,
loosen and remove screws
A and lift off top cover.
• To replace,
make certain lever B is
against arm top cover to eliminate possi
bility of damage. Position cover on top
of machine and replace and tighten
screws A.
REMOVING AND REPLACING
BOTTOM COVER
If your machine is a portable, remove the
carrying case base as instructed below.
• To remove,
tilt machine back and
remove retaining nut C, being careful
not to lose felt washer, and remove
cover from underside of machine.
• To replace,
position cover over bottom
of machine and replace felt washer and
retaining nut. Tighten retaining nut
with a screwdriver.
REMOVING AND REPLACING
CARRYING CASE BASE
• Turn machine so that back is toward
you. Tilt machine back and loosen and
remove the retaining nut C from the
center.
• Set machine upright and lift up and
out of base.
• Replace machine in base, after bottom
cover has been attached.
• Turn machine so that back is toward
you; tilt back and replace retaining nut.
Tighten retaining nut with a screwdriver.
REMOVING AND REPLACING
FACE PLATE
•
Loosen and remove screw D and
remove face plate by sliding it down
ward.
• Replace face plate by sliding top edge
of plate under edge of arm top cover.
• Align screw hole in plate with screw
hole in machine and replace and tighten
screw D.
62