Adjusting width of design, Adjusting stitch placement, Adjusting needle-thread tension – SINGER 518 Stylist User Manual
Page 33
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Adjusting Width of Design
To produce a Flexi-Stitch disc pattern,
the stitch width selector must be,moved
from the straight-stitch setting j to a^
setting from ^ to § . Stitch width is
increased as the dial is moved to the right.
Adjusting Stitch Placement
Flexi-Stitch disc patterns can be sewn in
either L(left), (center) or (right)
needle positions^HSenter needle position
is recommended.
Adjusting Width of Design
Special
I
Special
Stitch
I
Stitch
Placement Most Used
Placement
Only
Setting
Only
Adjusting Needle-Thread Tension
Some Flexi-Stitch disc patterns require
more needle-thread tension than others.
Make a test sample with the fabric, thread
and presser foot you plan to use so that
you can adjust tension to suit the stitch
you have chosen.
For your test sample, set the tension dial
on 3 or 4. Notice the stitching; if the fabric
puckers, decrease tension by turning the
dial to a lower number. Sew at moderate
speed.
Before moving needle position and stitch
width selectors make sure needle is above
fabric and the stitch length dial is OFF
buttonhole settings.
Adjusting Stitch Placement
THREAD ▼ TENS i ON
i2
'¿ 4
sS
CIOrxTl II
-IT................IT.
rn
Adjusting Needle-Thread Tension
31