Changing the light bulb, Removing the bulb, Replacing the bulb – SINGER 518 Stylist User Manual
Page 66: Replacing the slide plate
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Locks
Unlocks
This machine
is designed to
use a 15 watt
maximum light
bulb
CHANGING THE LIGHT BULB
CAUTION:
Before
removing
bulb,
disconnect
power-line
plug from electrical sup
ply.
Removing the Bulb
With thumb and forefinger lower the
light bracket. Do not attempt to unscrew
bulb. Press it up into socket and at same
time turn bulb over in direction shown to
unlock bulb pin.
Replacing the Bulb
Press new bulb into socket, with bulb pin
entering slot of socket, and turn it over in
direction shown to lock bulb in position.
Push bracket back into recess.
Changing the Light Bulb
Raise Presser Foot
and Needle
Lift Retaining
Spring into Slide
Plate Grooves
REPLACING THE SLIDE PLATE
You will not have any occasion to remove
the slide plate. However, if it should
accidentally become disengaged from the
machine, it is easily replaced.
• Raise presser foot and needle.
• Place slide plate in slideway with the
front edge close to, but not covering,
the retaining spring (as shown in
illustration).
• With a screwdriver, lift each end of the
spring into each of the side grooves on
the underside of the slide plate.
• Draw the plate gently toward you and
fully engage the spring.
•
• Close slide plate.
Replacing the Slide Plate
64