Darning with embroidery hoop, Preparation – SINGER 518 Stylist User Manual
Page 62
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
Darning with Embroidery Hoop
0
o
i
Feed-Cover Needle Plate
Darning With Embroidery Hoop
• Flexi-Stitch Disc Dial: 0 (Off)
• Any Pattern Disc
• Needle Position: ^ (center)
• Stitch Width: j (straight stitch)
• Stitch Length: In Fine Area
• Feed-Cover Needle Plate
• N6 Presser Foot
• Presser Bar: Lowered
Preparation
Remove presser foot with shank (by re
moving the screw which fastens the
shank to the presser bar). Attach feed-
cover needle plate. Instructions for chang
ing the needle plate are given on page 8.
1. Trim ragged edges from area to be
darned.
2.
Center worn section in embroidery
hoop.
3. Position work under needle over feed-
cover plate and /ower presser bar to
engage tension,
4.
Hold needle thread loosely with left
hand, turn hand wheel over, and draw
bobbin thread up through fabric. Hold
both thread ends and lower needle
Into fabric.
5. Outline area to be darned with running
stitches for reinforcement.
6.
Stitch across opening, moving hoop
under needle at a slight angle from
lower left to upper right. Keep lines
of stitching closely spaced and even
in length.
7. When opening is filled, cover area with
crosswise lines of stitching.
This method of controlling fabric move
ment with an embroidery hoop may be
used to do embroidering and mono-
gramming.
60