Removing machine, From cabinet, Important – SINGER 518 Stylist User Manual
Page 67
Attention! The text in this document has been recognized automatically. To view the original document, you can use the "Original mode".
REMOVING MACHINE
FROM CABINET
IMPORTANT;
• Do not attempt to remove hinges from
cabinet as this may result in damage to
the wood of the cabinet.
•
Pull cabinet away from wall to avoid
damage to wall or machine.
• Remove machine power-line plug from
electrical outlet
To Remove Machine From Cabinet:
1.
Tilt machine back until it rests on
hinges. Remove machine plug from
receptacle.
NOTE:
On
models
equipped
with
spring-assist plate (see Inset, Step 1),
remove screw which fastens clip to
machine. Remove electrical cord from
clip, then replace clip and screw (to
avoid loss of these items).
2. Loosen set screws that hold machine
on hinge pins by turning them counter
clockwise.
3. Lift machine straight up and off pins.
For ease of removal, stand behind
cabinet when lifting machine.
To Replace Machine in Cabinet:
Reverse the procedure used for removing
the machine.
• Be sure set screws in machine are un
screwed far enough to clear the open
ings forthe hinge pins.
• To keep hinge pins pointing up while
replacing the machine, slip an elastic
rubber band around both pins, making
sure the elastic band is over the
shoulder of each hinge as illustrated.
• Be sure set screws are firmly tightened
against hinge pins before lowering
machine into sewing position or into
storage position.
NOTE:
On
Models
equipped
with
spring-assist plate, lead electrical cord
into recess at bottom of plate; fit clip
on cord and fasten to machine, as
shown in inset. Step 1.
Step 2
Step 3
Hinge Pins
Elastic Band
65