ADLINK cPCI-6S10 - Manual (Page 52)

42 Hardware Platform Management
Response Fields
Get Sensor Event Enable
6 For sensors with threshold base events:
[7:4] – reserved.
[3] – 1b = select deassertion event for upper non-recoverable going high
[2] – 1b = select deassertion event for upper non-recoverable going low
[1] – 1b = select deassertion event for upper critical going high
[0] – 1b = select deassertion event for upper critical going low
For sensors with discrete events:
[7] – reserved
[6] – 1b = select deassertion event for state bit 14
[5] – 1b = select deassertion event for state bit 13
[4] – 1b = select deassertion event for state bit 12
[3] – 1b = select deassertion event for state bit 11
[2] – 1b = select deassertion event for state bit 10
[1] – 1b = select deassertion event for state bit 9
[0] – 1b = select deassertion event for state bit 8
1
Completion code
ipmitool ipmitool [parameters] sensor get <id>
Terminal
mode
[10 00 28 01 00 00 00]
Description
This command is used to get which sensor event is enable or no.
We can use ipmitool to get this information.