ADLINK cPCI-6S10 - Manual (Page 56)

46 Hardware Platform Management
Re-arm Sensor Event
Request Fields
ipmitool ipmitool [parameters] raw 0x04 0x2a 0x01 0x00
Terminal
mode
[10 00 2a 01 00]
Description This command is used to re-arm a sensor.
1
sensor number (FFh = reserved)
2 [7] - 0b = re-arm all event status from this sensor. If 0, following
parameter
bytes are ignored, but should still be written as 0, if sent.
[6:0] - reserved. Write as 000_0000b.
(3)* For sensors with threshold based events:
[7] - 1b = re-arm assertion event for upper non-critical going high
[6] - 1b = re-arm assertion event for upper non-critical going low
[5] - 1b = re-arm assertion event for lower non-recoverable going
high
[4] - 1b = re-arm assertion event for lower non-recoverable going low
[3] - 1b = re-arm assertion event for lower critical going high
[2] - 1b = re-arm assertion event for lower critical going low
[1] - 1b = re-arm assertion event for lower non-critical going high
[0] - 1b = re-arm assertion event for lower non-critical going low
For sensors with discrete events:
[7] - 1b = re-arm assertion event for state bit 7
[6] - 1b = re-arm assertion event for state bit 6
[5] - 1b = re-arm assertion event for state bit 5
[4] - 1b = re-arm assertion event for state bit 4
[3] - 1b = re-arm assertion event for state bit 3
[2] - 1b = re-arm assertion event for state bit 2
[1] - 1b = re-arm assertion event for state bit 1
[0] - 1b = re-arm assertion event for state bit 0