ADLINK cPCI-6S10 - Manual (Page 60)

50 Hardware Platform Management
Get Sensor Type
4 For threshold-base sensors
Present threshold comparison status
[7:6] – reserved
[5] – 1b = at or above (>=) upper non-recoverable threshold
[4] – 1b = at or above (>=) upper critical threshold
[3] – 1b = at or above (>=) upper non- critical threshold
[2] – 1b = at or above (<=) lower non- recoverable threshold
[1] – 1b = at or above (<=)lower critical threshold
[0] – 1b = at or above (<=)lower non- critical threshold
For discrete reading sensors
[7] – 1b = state 7 asserted
[6] – 1b = state 6 asserted
[5] – 1b = state 5 asserted
[4] – 1b = state 4 asserted
[3] – 1b = state 3 asserted
[2] – 1b = state 2 asserted
[1] – 1b = state 1 asserted
[0] – 1b = state 0 asserted
5 For discrete reading sensors only( optional)
[7] – reserved
[6] – 1b = state 14 asserted
[5] – 1b = state 13 asserted
[4] – 1b = state 12 asserted
[3] – 1b = state 11 asserted
[2] – 1b = state 10 asserted
[1] – 1b = state 9 asserted
[0] – 1b = state 8 asserted
ipmitool ipmitool [parameters] sensor get <id>
Terminal
mode
[10 00 2F 00]
Description
This command is used to get sensor type.
We can use ipmitool to get this information