ADLINK cPCI-6S10 - Manual (Page 58)

48 Hardware Platform Management
Response Fields
Get Sensor Reading
Example: Get Tmp421 sensor reading
(6)* For sensors with threshold based events:
[7:4] - reserved. Write as 0000b.
[3] - 1b = re-arm deassertion event for upper non-recoverable going
high
[2] - 1b = re-arm deassertion event for upper non-recoverable going
low
[1] - 1b = re-arm deassertion event for upper critical going high
[0] - 1b = re-arm deassertion event for upper critical going low
For sensors with discrete events:
(00h otherwise)
[7] - reserved. Ignore on read.
[6] - 1b = re-arm deassertion event for state bit 14
[5] - 1b = re-arm deassertion event for state bit 13
[4] - 1b = re-arm deassertion event for state bit 12
[3] - 1b = re-arm deassertion event for state bit 11
[2] - 1b = re-arm deassertion event for state bit 10
[1] - 1b = re-arm deassertion event for state bit 9
[0] - 1b = re-arm deassertion event for state bit 8
1
Completion code
ipmitool ipmitool [parameters] sensor get <id>
Terminal
mode
[10 00 2d 01]
Description
This command is used to get sensor reading.
We can use ipmitool to read each sensor’s reading value.