ADLINK cPCI-6S10 - Manual (Page 67)

Hardware Platform Management 57
cPCI-6S10
Get SDR
15 Operation Support
[7] - Overflow Flag. 1=SDR could not be written due to lack of space in
the
SDR Repository.
[6:5] - 00b = modal/non-modal SDR Repository Update operation
unspecified
01b = non-modal SDR Repository Update operation supported
10b = modal SDR Repository Update operation supported
11b = both modal and non-modal SDR Repository Update supported
[4] - reserved. Write as 0b
[3] - 1b=Delete SDR command supported
[2] - 1b=Partial Add SDR command supported
[1] - 1b=Reserve SDR Repository command supported
[0] - 1b=Get SDR Repository Allocation Information command
supported
ipmitool Ipmitool [parameters] raw 0xa 0x23
Terminal
mode
[28 00 23]
Description
Get a SDR record from repository
If get a partial SDR record, user should call “Reserve SDR
repository” to get a valid reservation id.
A partial get command means offset is not 0 or length is not 0xff.
A record id with 0x0000 is first record.
If a MC support both “Sensor Device” and “SDR repository
device”, “SDR repository device” will has been used first.
Ipmitool will check “Get_device_id” command to decide use
which SDR source.