EXFO IQS-12004B DWDM Passive Component Test System for IQS-500 - Manual (Page 207)

Automating or Remotely Controlling the System
DWDM Passive Component Test System 195
SCPI Error Messages
SCPI Error Messages
The following table contains a list of error messages.
Note: For more information about error messages, refer to the GPIB card
instructions manual NI-488.2 Function Reference Manual for Windows.
Error Number Description
1 Unable to initialize a hardware module.
2 Unable to detect a hardware module.
3 Unable to initialize the IQS-2600CT source module.
4 Unable to initialize the IQS-9401 wavelength
reference module.
5 Unable to initialize the IQS-5150 polarization state
adjuster module.
6 Unable to initialize the IQS-1600 power meter
module(s).
7 Required modules are not available or not installed.
8 Module initialization has stopped.
9 Invalid IQS-9401 calibration.
10 Unable to perform a power meter nulling.
11 Invalid power meter number. Unable to perform the
nulling.
12 Invalid nulling type.
15 Unable to start an acquisition at this time. An
acquisition is already in progress.
16 Unable to perform this test because some modules
are not selected or not installed.