EXFO IQS-12004B DWDM Passive Component Test System for IQS-500 - Manual (Page 215)

Automating or Remotely Controlling the System
DWDM Passive Component Test System 203
Configuring Your DWDM Passive Component Test System as a GPIB Controller
2. Remove the NI-Device 1.3 Standard software as follows:
2a. From the Control Panel, double-click the Add/Remove Programs
icon.
2b. Select the Change or Remove Programs function tab.
2c. From the list of currently installed programs, select NI-Device 1.3
Standard and click Remove.
3. Install the NI-488.2 1.70 software as follows:
3a. Insert the installation CD-ROM in the drive.
3b. On the Windows taskbar, click Start and select Run.
3c. Use the Browse button to find the GPIB Controller folder on the
CD-ROM, then select setup.exe.
3d. Click OK to start the installation. The installation is relatively
straightforward: click Next until you reach the end (Finish).