EXFO IQS-12004B DWDM Passive Component Test System for IQS-500 - Manual (Page 65)

Setting Up the DWDM Passive Component Test System
DWDM Passive Component Test System 53
Preparing the Test Setup
7. From the PDL Analysis group box, specify the required parameters.
For more information on the various parameters, see Configuring a
DUT on page 42.
Note: If you omit to check the Keep IL traces for all states of polarization (4)
box, you won’t be able to export these traces. For more information on
exporting, see Exporting Data on page 94.
Note: If you omit to check the Polarization Dependent Wavelength box, you
won’t be able to export these traces. For more information on exporting, see
Exporting Data on page 94.
8. If you selected Specified for the test type, the DUT Identification group
box is displayed. Use this section to select and identify the device that
will be tested. For more information, see Identifying the Current DUT
on page 54.
Note: At start-up, your access level is activated by default. For more information
about access levels, see Working with Access Levels on page 59.