EXFO IQS-12004B DWDM Passive Component Test System for IQS-500 - Manual (Page 54)

Setting Up the DWDM Passive Component Test System
42 IQS-12004B
Configuring a DUT
Configuring a DUT
Note: You must be working at the Supervisor level to access this window.
This window can be accessed via the Configure DUTs icon from the
Welcome/New Test window. For information on how to display this
window, see Opening a New Test Database on page 61.
Once the optical ports are correctly defined, you can configure DUTs based
on these ports. When clicking Add or Modify in the DUT Configuration
section, the following window appears where you can enter or modify
information about the DUT.
In the upper section of the DUT Configuration window, you enter
identification and test parameters. These parameters will automatically be
selected when performing a scan on a defined device.
Note: Once a device has been created, the Number of Ports cannot be modified.
³
Part Number: the part number for the DUT.
³
Description: a short description of the DUT.
³
Manufacturer: the name of the manufacturer.