LINK Systems LinkNet II - Manual (Page 36)

4.8.2 Down Time Code Configuration
To configure down time
codes, select “Configure”
and then “Down Time
Codes” from the LinkNet
menu. A dialog box similar
to Figure 4.17 will appear.
The listing shows the down
time code, the down time
description, and the down
time category.
Figure 4.17: Down Time Code Listing
After all additions,
changes, or deletions have
been made, click the “OK”
button. The DTC
descriptions will then be sent
to each press on the network
automatically.
4.8.2.1 Adding a Down Time Code
Figure 4.18: Down Time Code Configuration Dialog Box
To add a down time code (DTC),
click on the “Add DTC” button on the
down time code listing (see Figure
4.17). A dialog box similar to Figure
4.18 should appear. The settings in this
dialog box are:
Down Time Code: By default, the DTC
number is the next available number, but
may be changed to any unused number
between 1 and 250.
Description: Up to 25 characters can be
entered for the DTC description, but
note that the System 1100 can only
display the first 19 characters.
Category: The down time category can
be any of the standard categories or any
of the customer define categories. See
section 4.8.1 for details.
Customer Fields: LinkNet does not directly use the customer fields. These three fields are provided for
custom uses by, of course, the customer.
Manual Version 1.1 10/28/2001 4.14