LINK Systems LinkNet II - Manual (Page 88)

If a down time code is active, whether automatic or operator entered, a “CLEAR DOWN TIME
CODE” softkey will be displayed. Hitting this softkey will clear the down time code.
8.3 Network Job Storage on the OmniLink 5000 (Color OIT)
Virtually unlimited job storage is available when using an OmniLink 5000 with LinkNet. Jobs can
be stored from the OmniLink 5000 to LinkNet in the following manner:
• From the main menu of the OmniLink OIT, hit the “JOB SETUPS” softkey to enter the jobs screen.
• Hit the “STORE SETUP” softkey to enter the store screen. Note that the Run/Prog key MUST be in
the Prog position for this softkey to be available!
• Change the job number and job description, if desired. This step may be skipped if the job number
and job description as shown in this screen are already correct.
• Hit the “STORE SETUP TO NETWORK” softkey to send the job to the network. A status message
will be displayed near the bottom of the screen to show the progress of the job storage. A message
will appear indicating whether or not the store was successful. If the network is not on line, a
message will appear indicating this condition. A job CANNOT be stored to the network unless it is
online!
IMPORTANT: Jobs stored using the “STORE SETUP” softkey will still be stored as
local jobs on the OmniLink as they always have - NOT the network. A job stored on the
network is independent of the same job number stored at the OmniLink. If you change
the settings for a job on the network, it DOES NOT affect the settings of the same job
number stored on the OmniLink and vice versa! Make sure the job is sent to its intended
destination.
8.4 Network Job Recall on the OmniLink 5000 (Color OIT)
Jobs may be recalled from LinkNet to the OmniLink 5000 in the following manner:
• From the main menu of the OmniLink OIT, hit the “JOB SETUPS” softkey to enter the jobs screen.
• Hit the “RECALL SETUP” softkey to enter the recall screen. Note that the Run/Prog key MUST be
in the Prog position for this softkey to be available!
• Hit the “RECALL FROM NETWORK” softkey to enter the network job recall screen. Note that
this key will not be available if the network is offline.
• Hit the “RECALL NETWORK SETUP” key in the network recall screen and a prompt will appear
asking fore the job number to be recalled.
• Enter the job number to recall and hit the “ENT” button on the OmniLink OIT keypad. If the job
has not been previously stored on LinkNet, a “Job Not Found” message will appear. Otherwise, this
Manual Version 1.1 10/28/2001 8.4