LINK Systems LinkNet II - Manual (Page 72)

6.1.4 Report Tool Selection
Many reports allow the selection of the tool or tool for which they are to be run. For instance, a
report could be run to report only on tool “TOOL-0001”. The dialog box that will appear for these
reports should be similar to Figure 6.4.
Figure 6.4: Report Tool Selection Dialog Box
By default, all tools are included. The left list box shows tools that are not included in the report.
The right side shows tools that are included in the report. Select a tool from the left list box and hit the
“Add” button to move it to the right list box or hit the “Add All” button to include all tools in the report.
Similarly, select a tool from the right hand list and hit the “Remove” button to transfer it to the left hand
list box or hit the “Remove All” button to remove all tools from the report. When the tools are selected
as desired, hit the “OK” button to proceed or the “Cancel” button to cancel the report.
Manual Version 1.1 10/28/2001 6.4