LINK Systems LinkNet II - Manual (Page 47)

4.11.1.1 Tool General Settings
The “General” tool settings page (see Figure 4.28) has the following settings:
Tool Number: The tool number can be up to 50 alphanumeric characters.
Description: The tool description will show up in tool lists and reports.
Property Number: LinkNet does not directly use this field. It is provided for customer information.
Tool Manufacturer: The manufacturer of this tool. This field is used to track tool problems by
manufacturer.
Tool Issue Contact: The person to contact when problems or questions arise in connection with this
tool.
Date Manufactured: The date of manufacture of the tool.
Standard Setup Time: The average amount of time it takes to install this tool in a machine.
Standard Removal Time: The average amount of time it takes to remove this tool from a machine.
4.11.1.2 Tool Physical Characteristics Settings
Figure 4.29: Tool Configuration Physical Characteristics Dialog Box
The “Physical
Characteristics” settings page (see
Figure 4.29) contains information
about the physical nature of the
tool. The settings in this page are
not currently used by LinkNet,
but may be in the future. At
present, these are for
informational purposes. The
information and settings on this
page are:
Show Units In: All units on this
page can be shown in English or
metric units. Note that values can
be entered in one unit, and
displayed in another.
Minimum Stroke: The minimum
stroke necessary to run this tool
properly.
Shutheight: The shutheight necessary to run this tool.
Manual Version 1.1 10/28/2001 4.25