LINK Systems LinkNet II - Manual (Page 90)

8.6 Viewing Machine and Job Notes on the OmniLink 5000 (Color OIT)
OmniLink 5000 operator interface terminals can display notes entered at the LinkNet computer for
both the machine and the current job - if any have been entered. This requires the following steps:
• From the any screen, hit the “ACC” key on the OmniLink keypad to enter the “Quick Access”
screen.
• Hit the “LINKNET” softkey to go into the down time code screen (see Figure 8.4). Note that this
softkey will not be present if LinkNet is not enabled or if it is offline.
• Hit the “NETWORK NOTES” softkey to enter the notes screen. Any machine notes that have been
entered in the LinkNet machine configuration (see section 4.9.1.5 for details on how to enter
machine notes) will appear on the screen. If the notes are longer than a screen, then a “NEXT
PAGE” or “PREV PAGE” softkey will appear as appropriate.
• A softkey called “JOB NOTES” will appear when viewing machine notes, and a softkey called
“MACHINE NOTES” will appear while viewing job notes. Once in the notes screen, hit the “JOB
NOTES” softkey to display the notes entered for the currently selected job (see section 4.13.1.5 for
details on how to enter job notes). The same paging action is available as discussed for machine
notes above. Hit the “MACHINE NOTES” softkey to view the machine notes again.
Manual Version 1.1 10/28/2001 8.6