LINK Systems LinkNet II - Manual (Page 55)

4.13.1.2 Job Physical Characteristics Settings
The “Physical
Characteristics” settings page
(see Figure 4.36) contains
information about the physical
nature of the job. The settings in
this page are not currently used
by LinkNet, but may be in the
future. At present, these are for
informational purposes. The
information and settings on this
page are:
Show Units In: All units on this
page can be shown in English or
metric units. Note that values
can be entered in one unit, and
displayed in another.
Parts Per Pound of Material:
The expected number of parts
produced from one pound (or
kilogram if in metric mode) of material.
Figure 4.36: Job Configuration Physical Characteristics Dialog Box
Parts Per Piece of Material: If using pieces of material instead of coil fed material, this is the number
of expected parts per piece of material.
Off Fall Percentage: The percentage of material expected to be lost as “trimmings”.
Stroking Mode To Use: The stroking mode that should be used when running this job.
Manual Version 1.1 10/28/2001 4.33