LINK Systems LinkNet II - Manual (Page 82)

7.3 Network Job Storage on the OmniLink 5000 (Monochrome OIT)
Virtually unlimited job storage is available when using an OmniLink 5000 with LinkNet. Jobs can
be stored from the OmniLink 5000 to LinkNet in the following manner:
• From the main menu of the OmniLink OIT, hit the “JOB SETUPS” softkey to enter the jobs screen.
• Hit the “STORE SETUP” softkey to enter the store screen. Note that the Run/Prog key MUST be in
the Prog position for this softkey to be available!
• Use the “ENTER JOB #” softkey and the “ENTER DESC.” softkey to change the job number and
job description, if desired. This step may be skipped if the job number and job description as shown
in this screen are already correct.
• Hit the “STORE NETWORK” softkey to send the job to the network. A status screen will appear to
show the progress of the job send. A message will appear indicating whether or not the store was
successful. If the network is not on line, a message will appear indicating this condition. A job
CANNOT be stored to the network unless it is online!
IMPORTANT: Jobs stored using the “STORE SETUP” softkey will still be stored as
local jobs on the OmniLink as they always have - NOT the network. A job stored on the
network is independent of the same job number stored at the OmniLink. If you change
the settings for a job on the network, it DOES NOT affect the settings of the same job
number stored on the OmniLink and vice versa! Make sure the job is sent to its intended
destination.
7.4 Network Job Recall on the OmniLink 5000 (Monochrome OIT)
Jobs may be recalled from LinkNet to the OmniLink 5000 in the following manner:
• From the main menu of the OmniLink OIT, hit the “JOB SETUPS” softkey to enter the jobs screen.
• Hit the “RECALL SETUP” softkey to enter the recall screen. Note that the Run/Prog key MUST be
in the Prog position for this softkey to be available!
• Hit the “RECALL NETWORK” softkey to enter the network job recall screen.
• If the network is off line, a message indicating this will appear. Jobs may NOT be recalled from the
network if it is off line! Otherwise, a prompt will appear asking for the job number to recall.
• Enter the job number to recall and hit the “ENT” button on the OmniLink OIT keypad. If the job
has not been previously stored on LinkNet, a “Job Not Found” message will appear. Otherwise, this
screen will display the status of the job download. A message will appear at the end of the download
indicating success or failure or the job recall.
IMPORTANT: A job recalled from the network is independent of the same job number
recalled from regular internal job storage at the OmniLink. Make sure the job being
recalled is from the location intended!
Manual Version 1.1 10/28/2001 7.4