Section 1.3 output types, Section 1.4 data formats, Section 1.5 hardware features – Spectrum Controls 1734sc-OE2CIH User Manual
Page 10: Ection, Utput, Ypes, Ormats, Ardware, Eatures
1-2
Chapter 1: Module Overview
User’s Manual Pub. 0300272-01 Rev. A.0
Section 1.3
Output Types
The OE2CIH module supports two, user-selectable, current outputs of 4 to 20 mA and 0
to 20 mA.
Section 1.4
Data Formats
User-defined scaling is provided that allows you to scale any data send to the module to
any 16-bit number.
Section 1.5
Hardware
Features
The module contains a DeviceNet communications bus that uses a Controller Area
Network (CAN) that connects to an Ethernet adapter for communication with an external
PLC that uses RSLogix 5000. Channels are wired as current outputs.
Module configuration is done via the controller’s programming software. The module
configuration is stored in the memory of the controller. Refer to your controller’s user
manual for more information. The photograph and illustrations below show the module’s
hardware features:
Front
Panel