Spectrum Controls 1734sc-OE2CIH - Manual (Page 28)

3-4 Chapter 3: Configuring the Module
User’s Manual Pub. 0300272-01 Rev. A.0
The Select Major Revision dialog appears:
6. Select the major software revision (4 in this example) for the new module and
click OK.
7. Select the major software revision you need for the new module and click OK.
A listing for the selected module appears in the Controller Organizer tree, and
the following New Module dialog appears:
8. Specify the following:

Name. Specify name for the module. The name must be IEC 1131-3
compliant. This is a required field and must be completed. Otherwise
you receive an error message when you exit this tab. You also see an
error message if a duplicate name is detected, or you enter an invalid
character. If you exceed the maximum number of characters allowed by
the software, the extra character(s) are ignored.

Description. Add description for the module (128 characters
maximum).

Slot. Enter physical location of ENBT module in chassis.