Spectrum Controls 1734sc-OE2CIH - Manual (Page 25)

User’s Manual Pub. 0300272-01 Rev. A.0
Chapter 3
Configuring the Module with
RSLogix™ 5000
This chapter covers software configuration of the module. More detailed information
about ControlLogix I/O Modules in general, and additional information about features
described below can be found in the ControlLogix Digital I/O Modules User Manual
Publication 1756-UM058F-EN-P–April 2012, and in the RSLogix 5000 Online Help.
The add-on profile may be downloaded at www.spectrumcontrols.com .
The generic point IO module profile can be used to represent the OE2CIH module within
RSLogix 5000. The generic profile should be used for RSLogix 5000 versions 14 and
older. Before the generic profile can be added to the IO configuration, the proper
communication module needs to be added to the IO configuration first. Follow the
procedure below to add a communication module to RSLogix 5000.
1. Add the new local communication module to your project.
2. Configure the local module, including:
a. Naming the module
b. Choosing a Communication Format
c. Setting the Revision level
d. Setting the module location as necessary such as the slot number for a
1756-L61 module (or your selection)
e. Choosing an Electronic Keying method
3. Add the new remote module to your project, such as a 1734 Control Net adapter
or Ethernet Adapter (that is, 1734-ACNR or 1734-AENT, respectively).
4. Configure the remote module similarly to the local module.
5. Download the configuration to the controller.
Section 3.1 Configuring the Module with RSLogix 5000
Once you have correctly installed your module, configure it as follows.
1. If needed, install a current copy of the correct AOP software. (If this is not
available, you will install a generic module instead.)
2. Start up your RSLogix 5000 software.