Spectrum Controls 1734sc-OE2CIH - Manual (Page 19)

Chapter 2: Installation and Wiring 2-5
User’s Manual Pub. 0300272-01 Rev. A.0
2.4.2 Install Mounting Base
WARNING Hazard of damage to module on power up.
Debris that falls into the module could cause damage when
power is applied to the module.
During panel or DIN rail mounting of all devices, be sure that all
debris (such as metal chips or wire strands) is kept from falling into
the module.
To install the mounting base on the DIN rail, proceed as follows:
1. Position the mounting base vertically above the installed units (adapter power
supply or existing module).
2. Slide the mounting base down allowing the interlocking side pieces to engage
the adjacent module or adapter.
3. Press firmly to seat the mounting base on the DIN rail. The mounting base will
snap into place.
4. To remove the mounting base from the DIN rail, remove the module, and use a
small-bladed screwdriver to rotate the base locking screw to a vertical position.
This releases the locking mechanism. Then lift straight up to remove.