Spectrum Controls 1734sc-OE2CIH - Manual (Page 31)

Chapter 3: Configuring the Module 3-7
User’s Manual Pub. 0300272-01 Rev. A.0
12. The Select Major Revision dialog appears. Enter or select Major Revision value
and click OK:
13. Configure the remote Ethernet communication module as follows, and then click
OK.
The following New Module dialog appears:
14. View or specify the following options:

Name. Enter name of new module.

Description . If needed, enter a description for the module.

Comm Format . Select the communication format. For the 1734
AENT, Ethernet Adapter module, select Rack Optimization. This
selection limits data to the basic status and input data in order to
optimize the number of connections via a Rack Connection.

Slot . Not editable. Shows the slot number in which the module resides.

Chassis Size. Enter the size of the chassis in which the adapter resides.

Address/Host Name . Choose whether to enter the specific IP address
or Host Name of the module.

Electronic Keying . From the pull down menu, choose the keying
option you wish to use for this module. Electronic Keying options are
described earlier in this chapter.