Caution – Dukane ULTRASONIC GENERATOR/POWER SUPPLY LS 403-574-01 User Manual

Page 45

Advertising
background image

Page  3

Section 5 – Standard System Status and Controls

Dukane Manual Part No. 403-574-01

TEST
Hold the TEST key momentarily to activate ultrasound
and view system operating parameters.

The LCD screen will show the real time settings for
Amplitude, Power

(does not appear with Time Only

generators), and Operating Frequency.
This information is useful in troubleshooting.

While pushing the TEST key, look at the System Power
Output Level meter (See the illustration to the right.) There
should be at least one green

LED

segment lit.

IMPORTANT

- If more than three

LED

segments are

lit, with no load applied to the ultrasonic stack, make
sure the stack is properly assembled and not damaged.
During normal operation, the peak level

LED

remains lit

(approximately 1 second) until the next cycle begins.

Control Keys Right of the Display

Navigation Keys
Press the left and right navigation keys to move the
display’s cursor left or right respectively. Also, use these
keys to move up one level in the menu, or to move back
one level.
Press the up and down arrow keys to change the value of
a selected digit.

ENTER
Press the ENTER key to select a menu item (shown
by the selection indicators), and move to the next
level of the menu. Think of it as a “forward” key.

Press ENTER to confirm and store a selection in memory.

CANCEL
Press the CANCEL key to return to the previous screen
or cursor position. Think of it as a “back” key. Selection
is not stored in memory.

NOTE

To activate the TEST mode, the
system must be ONLINE.

AMPLITUDE

85 %

POWER

40 W

OPERATE FRQ 19990 Hz

LOAD

80

60

100

OVER

40

0

20

SYSTEM POWER OUTPUT LEVEL

SYSTEM OPERATING MODE

ON

LINE

OFF

LINE

POWER

TEST

# 1 PART COUNT 125
WELD TIME 0.080 S
POWER 1050 W
ENERGY 350 J

In this illustration, one LED segment is
shown as lit after TEST was pushed.

Left

Down

Up

Right

CAUTION

If the System Output Power
Level red overload indica-
tor is lit, that means there
is an overload fault. If this
happens, verify that the ultra-
sonic stack is not damaged.

Navigation Keys (4)

Advertising