Datalogic Scanning DS6300 - Manual (Page 22)

DS6300
2
2.2 MECHANICAL MOUNTING
2.2.1 Mounting the Scanner
The DS6300 reader can be positioned and installed in the best way possible as a result of the
Step-a-Head™ feature. Thanks to the separation between Head and Base, you can modify
the orientation of the decoder base, and therefore display-keypad and connector panels, while
keeping the optic head in the correct reading position. The reading head and the decoder base
can be rotated independently from each other allowing the installation even in the most critical
locations.
Fixing Screw (4)
Head Screws
Figure 7 - Step-A-Head™ Feat ure
o rotate the head follow the given procedure:
. detach the head from the base by unscrewing the four fixing screws;
. rotate the head in the desired position;
3. loosen but don't remove the two screws on top of the head;
4. affix the head onto the base carefully aligning the four fixing screws and progressively
tightening them about half-way;
5. completely tighten the two screws on top of the head;
6. completely tighten the four fixing screws.
T
1
2
8