Datalogic Scanning DS6300 - Manual (Page 76)

DS6300
3
3.4 PARAMETER DEFAULT VALUES
The following table contains the list of the factory default settings for the DS6300.
Genius™ also allows checking the parameter default values by selecting the "Compare
parameters" option available in the Tools menu and comparing the current scanner
configuration to the default one.
Parameter Default Setting
Code Definition
Code Combination Single Label
No read Message Global No Read Message
No Read String <CAN>
Multiple Read Filters Disabled (unchecked)
Code Label Settings #1
Code Symbology Interleaved 2 of 5
Label Length 8
Min Code Position 0
Max Code Position 255
Check Digit Disabled (unchecked)
Decoding Safety 1
Decoding Severity 3
Match String Rule Match
Pattern Match String Empty
Match Direction Rule Disable
Code Label Settings #2
Code Symbology Code 39
Label Length Variable
Minimum Label Length 1
Maximum Label Length 60
Min Code Position 0
Max Code Position 255
Check Digit Disabled (unchecked)
Decoding Safety 1
Decoding Severity 3
Match String Rule Match
Pattern Match String Empty
Match Direction Rule Disable
Operating Modes
Operating Mode Selection On Line
On Line Options On Line 1 Input
Start Input Number 1
Start Input Active Level Active Closed
Reading Phase Timeout Disabled (unchecked)
Verifier Disabled (unchecked)
Reading System Layout
Device Assignment Alone
Modify&Backup Lon Slave Configuration Disabled (unchecked)
Enable A.S.R. Disabled (unchecked)
62