Datalogic Scanning DS6300 - Manual (Page 52)

DS6300
2
ATTENTION
If using the “45° Skew” installation, the scanner reading performance is
not guaranteed to match that measured for the standard installation with
Skew angle between 10° - 20° (see reading diagrams in par. 4.3.1).
The ST-210 mounting bracket is an accessory of the D
NOTE
S6300 standard
model available in the US-60 kit (order no. 890001020).
2.7 TYPICAL LAYOUTS
The DS6300 scanners can be connected in a variety of layouts depending on the number of
everal power supplies are available to power the reading stations. Photoelectric sensors
rs (see par. 3.2 for details).
he accessories and cables indicated in the following figures are Datalogic products. We
the correct system functioning.
rface. The Main interface can be selected for RS232 or RS485 full-duplex
ommunications.
Two different layouts are available according to the DS6300 reader model used for the
connection.
scanners used and the required complexity of the reading station. These layouts range from
Single Stand Alone to Complex Lonworks Networks.
S
used as code presence sensors and optical encoders to signal conveyor speed are also
available accessories.
The following typical layouts refer to the system hardware configurations, but they also
require the correct setup of the software configuration paramete
T
suggest their use to guarantee
2.7.1 Point-to-Point
Using a Point-to-Point layout, the data is transmitted on the Main interface as well as on the
Auxiliary inte
c
38