Ethernet connector – Datalogic Scanning DS6300 User Manual

Page 44

Advertising
background image

DS6300

2

2.3.3 Ethernet

Connector


This connector is only available for DS6300 Ethernet models and allows the Ethernet
connection between the host and the scanner.

8

1

Figure 39 – Cable RJ45 Male Modular Connector


1

8

Figure 40 – DS6300 RJ45 Female Modular Connector



This interface and the connector pinout (see the following table) are IEEE 802.3 10 BaseT
and IEEE 802.3u 100 BaseTx co

Modu

mpliant.

RJ45

lar Jack Pinout

P

in

Name

Function

1

TX +

Transmitted data (+)

2

TX -

Transmitted data (-)

3

RX +

Received data (+)

6

RX -

Received data (-)

4, 5, 7, 8

N.C.

Not connected



In order to meet EMC requirements:
• use Eth shielded cable

connect the E


thernet interface cable shield to the plant earth ground

NOTE

The cable shield must be connected to the chassis of both connectors.
A ferrite (type Stewart 28A2029-0A0) may also be applied on the scanner
side of the Ethernet cable to reduce electrical noise.


30

Advertising