Synaccess Networks NP-0801DTM - Manual (Page 103)

3GPP TS 27.007 AT COMMANDS
103 HSPA+ AT Commands Reference Guide
<stat> Registration status.
<lac> Location area code in hexadecimal format. For example "00C3" equals 195 in
decimal.
<ci> Cell ID in hexadecimal format.
<AcT> Access technology of the registered network:
0 GSM
2 UTRAN
<rac> String type, one byte routing area code in hexadecimal format.
Note: <lac>, <Ci>, <AcT> and <rac> are reported only if <mode>=2 and the mobile is registered on some network
cell.
Notes
„
Reference: 3GPP TS 27.007.
Define PDP Context +CGDCONT
Set command specifies PDP context parameter values for a PDP context identified by the (local) context
identification parameter, <cid>.
Read command returns the current settings for each defined context in the format:
+CGDCONT: <cid>,<PDP_type>,<APN>,<PDP_addr>,<d_comp>,
<h_comp>[,<pd1>[,…[,pdN]]][<CR><LF>+CGDCONT: <cid>,
<PDP_type>,<APN>,<PDP_addr>,<d_comp>,<h_comp>
[,<pd1>[,…[,pdN]]][…]]
Test command returns values supported as a compound value.
Syntax
Command Command type
AT+CGDCONT=[<cid>[,<PDP_type>[,<APN>[,<PDP_addr>[,<d_comp>
[,<h_comp>[,<pd1>[,…[,pdN]]]]]]]]]
AT+CGDCONT? Read
AT+CGDCONT=?
Parameters and Values
<cid> PDP Context Identifier. Numeric parameter that specifies a PDP context
definition.
1‐max The value of max is returned by the Test command.
Note : A special form of the Set command, +CGDCONT=<cid>, causes the values
for context number <cid> to become undefined.
<PDP_type> Packet Data Protocol type. String parameter that specifies the type of packet data
protocol
"IP" Internet Protocol
<APN> Access Point Name. String parameter that is a logical name used to select the
GGSN or the external packet data network. If the value is empty (“”) or omitted,