Syntax, Parameters and values, Tone classes volume #tsvol – Synaccess Networks NP-0801DTM User Manual
Page 309
AUDIO COMMANDS
309
HSPA+ AT Commands Reference Guide
Test command returns the range of supported values for <toneId>,
<AcT>
.
Syntax
Command
Command type
AT# TONEEXT=<toneId>,
<AcT>
Execute
AT#TONEEXT=?
Test
Parameters and Values
<toneId>
ASCII characters in the set (0‐9), #,*,(A‐D),(G‐L),Y,Z.
(0‐9), #,*,(A‐D)
DTMF tone.
G‐L
User‐defined tones.
Y
Free tone.
Z
Busy tone.
<AcT>
Action to be performed.
0
Stop the <toneId> if running.
1
Start the <toneId>.
Tone Classes Volume #TSVOL
Set command selects the volume mode for one or more tone classes.
Read command returns for each class of tones the last setting of
<mode>
and, if
<mode>
is not 0, of <volume> too,
in the format:
#TSVOL: 1,<mode1>[,<volume1>]<CR><LF>
…
#TSVOL:128,<mode128>[,<volume128>]
Test command returns the supported range of values of <class>,
<mode>
and <volume>.
Syntax
Command
Command type
AT#TSVOL=<class>,
<mode>
[,<volume>]
Set
AT#TSVOL?
Read
AT#TSVOL=?
Test