Syntax, Parameters and values – Synaccess Networks NP-0801DTM User Manual
Page 322
AUDIO COMMANDS
HSPA+ AT Commands Reference Guide
322
#DVICFG: <config>,<samplerate>,< samplewidth >,<audiomode>,<edge>
Test command reports the range of supported values for:
<config>,<samplerate>,< samplewidth >,<audiomode>,<edge>
Syntax
Command
Command type
AT#DVIEXT=<config>,[<samplerate>,[<sampleclock>,[<audiomode>,>,[<edge>]]]]
Set
AT#DVIEXT?
Read
AT#DVIEXT=?
Test
Parameters and Values
<config>
0
Burst mode.
1
Normal mode. Default: 1.
<samplerate>
0
Audio scheduler sample rate 8KHz. Default: 1.
1
Audio scheduler sample rate 16KHz.
<samplewidth>
0
16 bits per sample. Default: 0.
1
18 bits per sample.
2
20 bits per sample.
3
24 bits per sample.
4
32 bits per sample.
<audiomode>
0
Mono mode.
1
Dual mono. Default: 1.
<edge>
0
Data bit is transmitted on falling edge of clock and sampled on rising edge of
clock. Default: 0.
1
Data bit is transmitted on rising edge of clock and sampled on falling edge of
clock.
Values for <edge> are valid only in Burst Mode. Normal Mode is 0.